Elantra tire pressure by tire size

From the Tires and Wheels table in chapter 10 of the complete 2025 Elantra (CN7) owner's manual, which Hyundai's owner site posts under Elantra N Line and which says it applies to all models of the vehicle, read November 4, 2026. The 2026 Elantra manual posted there refers to the complete manual and to the tire label for these figures. The 2025 manual lists wheel lug nut torque of 79-94 lbf·ft (11-13 kgf·m, 107-127 N·m).

The 2026 Elantra manual says all specifications, sizes and pressures, can be found on a label attached to the driver's side center pillar. Use that label if it differs from this table.

Which tire your 2026 Elantra has

Wheels and tires by trim from the 2026 Elantra and 2026 Elantra Hybrid features and specs on hyundaiusa.com, read November 4, 2026; pressures matched by tire size from the owner's manual tables above and in the 2026 Elantra Hybrid manual. Every trim lists a Tire Pressure Monitoring System (TPMS) as standard. The Elantra N is a separate model and is not covered here.

See the Elantra at Michigan City Hyundai, or check our Elantra MPG guide.

Elantra Hybrid tire pressure

From the Tires and Wheels table in chapter 2 of the 2026 Elantra Hybrid owner's manual, read November 4, 2026. That table lists no compact spare.

How to check Elantra tire pressure

The Elantra manual says to check every tire, including the spare, at least once a month, with a good quality tire pressure gauge. You cannot tell if your tires are properly inflated simply by looking at them.

1. Check when the tires are cold. The 2026 Elantra manual defines cold tires as a vehicle that has not been driven for at least three hours, or has been driven less than 1 mile (1.6 km).
2. Remove the valve cap and press the gauge firmly onto the valve to get a reading.
3. Compare it with the pressure on the tire and loading information label. If it is low, add air until it reaches the recommended pressure.
4. If you overfill, release air by pushing on the metal stem in the center of the tire valve, then recheck with the gauge.
5. Put the valve caps back on. Without the cap, dirt or moisture may get into the valve core and cause air leakage.

Warm tires normally read 4 to 6 psi (28 to 41 kPa) above the recommended cold pressure. The manual says not to release air from warm tires to adjust the pressure, because the tires would then be under-inflated.

Cold weather and snow tires

From the Tires and Wheels notice, Tire Pressure Monitoring System and snow tire sections of the 2025 Elantra owner's manual, read November 4, 2026.

Elantra tire pressure monitor (TPMS)

The 2025 Elantra manual says you can check tire pressure in the Driving Assist view mode on the instrument cluster. The pressures appear after a few minutes of driving; if they do not appear while the car is stopped, the message "Drive to display" appears. The displayed values may differ from a tire gauge reading.

To change the pressure unit on the infotainment system, the manual gives this path: Settings > General > Units > Tire Pressure Unit > psi, kPa or bar.

If the low tire pressure telltale comes on, the manual says to reduce speed, avoid hard cornering, stop and check your tires as soon as possible, and inflate them to the pressure on the label on the driver's side center pillar. The TPMS is not a substitute for checking pressure with a gauge. For other cluster lights, see our Hyundai warning lights guide.

Michigan City Hyundai service hours

From the service department hours in Michigan City Hyundai's website structured data, November 4, 2026. No Sunday service hours are listed. Holiday hours can differ.